Use and Care Manual
key, the light will stay orange for 3 seconds
4
The lock will ‘Beep’ continuously & the green light will flash for the last 30
seconds of the Time Delay period
5
Once the continuous ‘Beeps’ stop, the lock will unlock for 5 seconds
6
Turn the handle to open safe
LOW BATTERY WARNING
[ Time to change your batter y]
When you enter your code, a green light & a red light will turn on for
approximately 5 seconds; you will also hear 10 ‘Beeps’. The safe will probably
not unlock when you get this response
When you enter your code, a green light will turn on for approximately 1
seconds. The safe will not unlock when you get this response
If your keypad has no response [no beeps; no lights]
CHANGING YOUR BATTERIES
1
Locate the battery cover on the bottom edge of the keypad & remove the
cover by pulling on the tab
2
Carefully & gently remove the 9-V battery from the compar tment
C AUTION : Hold onto battery connector to avoid pulling
wires out of housing.
3
Carefully re-insert the new 9V batter y, do not force the battery into the
compartment
4
The lock will retain all current codes & settings
9V
1
2
3
4
5
6
7
8
9
#
*
0
ĂƩĞƌLJ
ŽŵƉĂƌƚŵĞŶƚ
ĂƩĞƌLJ
ŽŶŶĞĐƚŽƌ
ϵsĂƩĞƌLJ
PG.7
|
MSL-500
ELECTRONIC LOCK INSTRUCTIONS