Use and Care Manual

SETTING SINGLE USER & DUAL USER MODE
Single User Mode [Only 1 code needed to open safe]
1
Input :
*
-
*
[lock will ‘Beep’ 2 times]
2
Input : 1-5-8-# [lock will ‘Beep’ 2 times]
3
Input : Current Master Code-# [lock will ‘Beep’ 2 times]
4
Input : 1-# [light stays green for 3 seconds]
Example :
*
-
*
-1-5-8-#-Master Code-#-1-#
[ This will delete User 1]
Unsuccessful Code Change : 5 ‘Beeps’ [repeat steps 1 - 4]
Dual User Mode [2 seperate codes needed to open safe]
1
Input :
*
-
*
[lock will ‘Beep’ 2 times]
2
Input : 1-5-8-# [lock will ‘Beep’ 2 times]
3
Input : Current Master Code-# [lock will ‘Beep’ 2 times]
4
Input : 2-# [light stays green for 3 seconds]
Example :
*
-
*
-1-5-8-#-Master Code-#-2-#
Unsuccessful Code Change : 5 ‘Beeps’ [repeat steps 1 - 4]
[ To use this mode, refer to How To Open Your Safe on pg. 2]
SETTING TIME DELAY [0 - 59 minute time delay]
1
Input :
2
Input :
*
-
*
-1-5-9-# [lock will ‘Beep’ 2 times]
3
Input : Current Master Code-# [lock will ‘Beep’ 2 times]
4
Input : 2-# [light stays green for 3 seconds]
01 = 1 minute Time Delay
59 = 59 minute Time Delay
00 = Will turn Time Delay mode off
Example :
*
-
*
-1-5-9-#-Master Code-#-3-#
[ This will set the Time Delay period to 3 minutes]
Unsuccessful Code Change : 5 ‘Beeps’ [repeat steps 1 - 4]
The Master Code will override the Time Delay
HOW TO OPEN IN TIME DELAY MODE
1
Enter any valid code other than the Master Code
2
Once the code is entered the Time Delay will activate
3
During the Time Delay, codes will not be accepted. When you press any
MSL-500 ELECTRONIC LOCK INSTRUCTIONS
|
PG.6