Use and Care Manual

SAFE OPERATION & PROGRAMMING
Your Master Code is factory set to : 1-2-3-4-5-6-7-8
NOTE : The Master Code should always be held by the owner of the safe.
You will not be able to activate/delete users, set up single/dual entr y and
set up time delay without the Master Code.
HOW TO OPEN YOUR SAFE
Single User Mode [Default Setting]
1
Input : Code - # [light stays green for 5 seconds]
2
Turn the handle clockwise before the green light disappears
Example : 1-2-3-4-5-6-7-8-#
Invalid Code: Red light along with 5 ‘Beeps’
Dual User Mode
[Please refer to Setting Single User & Dual User Mode; pg. 4]
1
Input : 1
st
Code - # [lock will ‘Beep’ 2 times]
2
Input : 2
nd
Code - # [light stays green for 5 seconds]
3
Turn the handle clockwise before the green light disappears
Example : 1
st
Code - # - 2
nd
Code - #
Invalid Code: Red light along with 5 ‘Beeps’
Wrong Try Penalty
If 4 wrong codes are entered, the keypad will not accept any codes for 5
minutes. If you press any key during this penalty, the orange light will turn on
for approximately 2 seconds and you will hear a ‘Beep’.
CHANGING THE MASTER CODE [Code length : 3 - 8 digit code]
NOTE : Always perform this operation with the door opened! Test the
new code several times before closing the door.
1
Input :
*
-
*
[lock will ‘Beep’ 2 times]
2
Input : 8-8-8-# [lock will ‘Beep’ 2 times]
3
Input : Current Master Code-# [lock will ‘Beep’ 2 times]
4
Input : New Master Code-# [lock will ‘Beep’ 2 times]
5
Re-Input : New Master Code-# [light stays green for 3 seconds]
Example :
*
-
*
-8-8-8-# - Master Code - # - New Master Code - # - New Master Code - #
Unsuccessful Code Change: 5 ‘Beeps’ [the old code is still valid];
repeat steps 1 - 5
MSL-500 ELECTRONIC LOCK INSTRUCTIONS
|
PG.4