Owner`s manual

PAGE 30

Removing the Tr a n s aT l a n T i c Cover for Tube Replacement

**** Before removing cover make sure the ampliﬁer is powered off and the AC cord is unplugged.

Remove the two screws from the left and right side of the ampliﬁer.

Caution: There are two wires connecting the chassis to the cover. Do not lift the cover straight up. Carefully rotate the cover forward maintain-

ing close distance between the chassis and front of the cover.

Once the cover is free from chassis, carefully rest the cover on it’s top directly in front of the ampliﬁer. As a convenience, you may remove the

wire from the LED strip attached to the cover (see close-up photo below) by unplugging it. This will allow you to remove the cover from your

workspace.

After completing tube maintenance, reverse the above steps to replace the cover.

Note: Use care when completing these steps as a careless act can scratch the chassis or cover.