Owner`s manual

PAGE 34
STRATEGY Lid Removal Instructions
Please read these instructions all the way through before proceeding. It is not necessary to remove the trim bars in order to remove
the lid.
1. Remove 4 screws from each side of the lid:
2. Remove two screws from the back panel:
3. Lift the lid half way up by lifting with one hand in one rear opening and one hand under the front edge, at opposite corners. The
weight of the amp will allow the lid to come up.
4. With the lid half way up, lift the display LED connector from the EQ circuit board:
5. Remove the lid completely.
Replace the lid in reverse order. Be sure to reinstall the LED connector in the same position. Installing it incorrectly may damage the
display LEDs. Use caution when reinstalling the top two screws on each side of the lid—DO NOT force the screws in.
MAINS
FUSE
EXT
SWITCHING
LOOP
EXT
SWITCH
HAND BUILT
IN PETALUMA,
CALIFORNIA U.S.A.
TUBE GUIDE
3 x 12AX 7 8
x KT-88
BASS STRATEGY
VACUUM TUBE
AMPLIFIER
FOOT
SWITCH
USE
WITH
TWO
8Ω
CABS
4 OHM 4 OHM 8 OHM 2 OHM 2 OHM
D.I. OUT
MUTE SOLO
VOICE EQ
SLAVE
LEVEL
RETURN
SEND
TUNER
SLAVE
CAUTION!
WARNING!
D.I. LIFT
GROUND
PATENTED
6,724,897
h
8 A
SLO
BLO
120 V~
60 Hz
8 A
USE
WITH
TWO
4Ω
CABS
+
-
SPEAKER
MUTE ON UNLESS SPKR IN
OUTPUT
HOME OF TONE
®
®
EQ 0
EQ IN
EQ FS
HALF
FULL PWR
LOW PWR 33Hz 80 150 300 600 900 2K 5K 8K
D.I. PRE
POST
MUTE
SIL. REC.
LED CONNECTOR
RED WIREWHITE WIRE