User Manual

®
®
supplies), connect the external power source here. SEE
WARNING BELOW!
NOTE: The External DC Power Supply is Not Included.
WARNING!!! To avoid immediate damage to your unit and
the voiding of your warranty, the External Power Supply
MUST be 9VDC with a NEGATIVE CENTER plug polarity
and a jack size of 2.1mm x 5.5mm. Do NOT connect a (Volt
AC Power Supply to the EXT Power Jack!
The internal battery is automatically disconnected by a
switching element in the External DC Receptacle on the
pedal. However, if you know you will not be using battery
power for an extended period – for example, if you are
mounting the unit to your pedal board permanently - it is
wise to remove the battery to avoid possible damage from
long-term battery corrosion.
INTERNAL BATTERY:
This unit can operate on either
a 9-Volt battery or a standard 9-Volt “wall-wart” DC power
supply. The unit is shipped from the Factory with a long-life
9-Volt Battery to facilitate easier trial demonstration in a
music store environment.
NOTE: The internal battery is switched to an “ON” state
(drawing voltage) by a switching element in the INPUT jack.
Disconnect the cable from the ¼” INPUT jack whenever the
unit is not in use to prolong battery life.
BATTERY REPLACEMENT:
To access the 9-Volt bat-
tery for inspection, replacement or removal; make sure the
External Power jack is disconnected, remove the four Phil-
lips- head screws from the four corners of the bottom lid
and remove it, note the orientation/direction of the battery
and terminals – and remove it. Replace if necessary.
NOTE: Any type of 9-Volt battery will work in this device if
it is fully charged and functional. Carbon Zinc, Alkaline or
even Nickel Cadmium Rechargeable type batteries are all
acceptable replacements. Some pedal aficionados prefer
the “sweetness” they claim to hear from standard Carbon
Zinc type batteries, but you will have to decide what type
best serves your needs.
SPECIFICATIONS:
• Dimensions (W/D/H): 2.87” x 4.77” x 2.28” (73mm x
122mm x 58mm)
• Weight: 0.802lbs (364g) with battery, 0.702lbs (319g)
without battery
• True Bypass Switching
• Battery Type: 9VDC (one)
• Power Consumption (Current Draw): 9VDC/15mA
• DC Adapter (Optional): Power Jack 2.1mm x 5.5mm,
9VDC with Negative Center (Regulated Recommend-
ed)
• Input Impedance: 1M Ohm (500k Ohm minimum)
• Output Impedance: 10k Ohm
SAMPLE SETTINGS: SAMPLE SETTINGS: USER SETTINGS:
MID-GAIN CRUNCH FLUX BUMP
SINGING SOLO SLAM IT