User's Manual

Where to Go From Here

AP1000 Beta Test

Change LED Appearance

If you want to change the appearance of the LEDS, follow these steps:

1. From the controller, click Configuration > Devices > AP, and then select the AP.

2. Select one of these settings for the LED Mode setting:

— Normal: LEDs are as described below

— Node ID: Not supported in release 4.1

— Blink: Sets all LEDs flashing; this is useful to locate an AP

— Dark: Turns off all LEDs

3. Click OK.

Where to Go From Here

Now that the AP1000 is installed, refer to the Meru System Director Getting Started Guide for instruc-

tions on initializing the hardware. Return to this chapter to check the status of the LEDs once the WLAN

is operational.