User's Manual
Table Of Contents
- About This Guide
- Meru Access Points and Radio Switch
- Installing the AP300
- Installing the AP200
- Installing the OAP180
- Installing the AP150
- Installing the RS4000
- Specifications
- AP Accessories
- Mounting Bracket Stencils
- Cautions and Warnings
- Regulatory Information
50 Meru Access Point and Radio Switch Installation Guide © 2008 Meru Networks, Inc.
Installing the Access Points
Figure 29: Brackets Attached to a Pole
3. Use the included nuts to tightly secure the wireless OAP180 to the bracket.
4. Connect the
OAP180 bracket and the pole bracket.
Mounting OAP180 with the Wall-Mounting Bracket
Attach the bracket to a wall with the flat side flush against the wall. Follow these steps
to mount the unit to a wall using the wall-mounting bracket:
1. Position the bracket in the intended location and mark the position of the four
mounting screw holes.
2. Drill holes in the wall that match the screws and wall plugs included in the bracket kit,
and then secure the bracket to the wall.
3. Use the included nuts to tightly secure the
OAP180 to the bracket.
4. Connect the two brackets as shown below.
Note:
Always attach the bracket to a pole with the open end of the mounting grooves
facing up.
00201
A
ttach the bridge
w
ith bracket to
a
ffixed plate on pole
0
2