User's Manual
Table Of Contents
- About This Guide
- Meru Access Points and Radio Switch
- Installing the AP300
- Installing the AP200
- Installing the OAP180
- Installing the AP150
- Installing the RS4000
- Specifications
- AP Accessories
- Mounting Bracket Stencils
- Cautions and Warnings
- Regulatory Information
© 2008 Meru Networks, Inc. Installing the OAP180 45
Chapter 4
Installing the OAP180
This chapter describes how to physically install the OAP180. It contains the following sec-
tions:
z Safety Precautions
z Unpacking the OAP180
z Installation Requirements
z Installing the Access Points
z Where to Go From Here
z Checking LED Activity
Safety Precautions
IMPORTANT—Read and follow the instructions in Appendix E, “Regulatory Information” on
page 115 before installing and operating this product.
This product is intended to be supplied by a UL Listed power supply, marked Class 2 or
LPS, and rated minimum 5 Vdc, 3A.
Caution!
The OAP180 is not certified for plenum installations, and should not be
installed in the plenum space.