User's Manual
Table Of Contents
- Contents
- Introduction
- OAP180 Access Point Features
- Special Release Software for Meru Controllers
- OAP180 Hardware Installation Instructions
- Limitations and Advisories
- Regulatory Information
- Documentation for this Release
- Contacting Meru
OAP180 Hardware Installation Instructions 9 of 24
© 2007 Meru Networks, Inc.
Mount the Unit
The OAP180 can be mounted on the following two surfaces (brackets are included):
z 1.5 to 2 inch diameter pole
z Wall
Mounting OAP180 with the Pole-Mounting Bracket
Perform the following steps to mount the unit to a 1.5 to 2 inch diameter steel pole or
tube using the mounting bracket:
1. Attach the OAP180 to the mounting bracket shown in Figure 3.
Figure 3: Square Mounting Bracket Attaches to Bottom of OAP180