User's Manual

18 of 24 OAP180 Hardware Installation Instructions
© 2007 Meru Networks, Inc.
Configure OAP180 Radio Operation with the CLI
To configure radio parameters of OAP180 through the IOSCLI, follow these steps from
controller. This example uses AP ID 1 and interface IDs 1 and 2:
1. First, configure AP ID 1 and Interface ID 1 (B/G Interface):
MC3000# configure terminal
MC3000(config)# interface Dot11Radio 1 1
MC3000(config-if-802)# channel 1
MC3000(config-if-802)# rf-mode 802.11g
MC3000(config-if-802)# exit
MC3000(config)#
2. Next, configure AP ID 1 and Interface ID 2 (A Interface):
MC3000(config)# interface Dot11Radio 1 2
MC3000(config-if-802)# channel 48
MC3000(config-if-802)# exit
MC3000(config)# exit
3. Save the configuration:
MC3000# copy running-config startup-config
4. Check the configuration of both interfaces:
MC3000# show interfaces Dot11Radio 1 1
Wireless Interface Configuration
AP ID : 1
AP Name : OAP180
Interface Index : 1
AP Model : OAP180
Description : ieee80211-1-1
Administrative Status : Up
Operational Status : Disabled
Last Change Time : 2007/04/26 01:18:29
Radio Type : RF3
MTU (bytes) : 2346
Channel : 1
Short Preamble : on
RF Band Support : 802.11bg
RF Band Selection : 802.11g
Antenna Selection : Left
Transmit Power (dBm) (low,medium,high) : 20,20,20
AP Mode : Normal
Fixed Channel : off
Scanning Channels :
Protection Mechanism : 802.11-1999
Protection Mode : auto
Number of Antennas : 1
Dual abg Support : off