Technical data

Adding an ESS with the CLI

2. Configure each radio for Virtual Cell by following these steps:

a. Click Configure > Wireless > Radio

b. Select a radio.

c. Set Virtual Cell as “On”

d. Save the configuration.

Configuring Virtual Cell Support for AP300 or AP400 with the

CLI

Virtual Cell is enabled by default on Meru APs. However, note that if you turn Virtual

Cell off at an AP300/AP400 radio then Virtual Cell is off for that radio, even if the

ESS in use has Virtual Cell configured. Both the radio and the ESS in use have to have

Virtual Cell enabled for the AP to use Virtual Cell. (This does not apply to AP1000.)

You can see the Virtual Cell setting by using the CLI command show interfaces

Dot11Radio. For example:

vcell22# show interfaces Dot11Radio 2 1

Wireless Interface Configuration

AP ID : 2

AP Name : AP-2

Interface Index : 1

AP Model : AP320

Interface Description : ieee80211-2-1

Administrative Status : Up

Operational Status : Enabled

Last Change Time : 09/27/2008 02:44:52

Radio Type : RF6

MTU (bytes) : 2346

Channel : 11

Operating Channel : 11

Short Preamble : on

RF Band Support : 802.11abgn

RF Band Selection : 802.11bgn

Antenna Selection : Left

Transmit Power High(dBm) : 18

AP Mode : Normal

Scanning Channels :

1,2,3,4,5,6,7,8,9,10,11,12,13,14,34,36,

38,40,42,44,46,48,52,56,60,64,100,104,108,112,116,120,124,128,132,136,140,

149,15

3,157,161,165

Protection Mechanism : wmm-txop

Protection Mode : auto

Number of Antennas : 3

Dual abg Support : off

Channel Width : 20-mhz

MIMO Mode : 2x2

Note:

Configure multiple radios with Bulk Update.