Technical data

Configure Controller Parameters From the CLI

Limit Wireless Client Access to the Controller From the CLI

Administrators wishing to block access to the controller management utilities for

wireless clients can do so with the no management access command. When wireless

management access is blocked, all packets sent to the controller by wireless clients

are dropped except for those used for Captive Portal.

To remove wireless access to the controller, enter the command:

controller(config)# no management wireless

To check the management status, use the show controller command. The line near

the bottom of the output, Management by wireless stations: will show either an on

or off value.

MC3000# show controller

Global Controller Parameters

Controller ID : 1

Description : InteropLab-MC1000

Host Name : InteropLab-MC1000

Uptime : 02d:13h:36m:19s

Location : DC Cabinet 6

Contact : Network Group

Operational State : Enabled

Availability Status : Online

Alarm State : No Alarm

Automatic AP Upgrade : off

Virtual IP Address : 172.26.96.11

Virtual Netmask : 255.255.255.0

Default Gateway : 172.26.96.1

DHCP Server : 10.0.0.10

Statistics Polling Period (seconds)/0 disable Polling : 60

Audit Polling Period (seconds)/0 disable Polling : 60

Software Version : 4.1-49

Network Device Id : 00:90:0b:0e:a8:61

System Id : 1FC4B274070D

Default AP Init Script :

DHCP Relay Passthrough : on

Controller Model : MC1000

Country Setting : United States Of America

Manufacturing Serial # : 2008MC10001039

Management by wireless stations : on

Controller Index : 0

Topology Information Update : off

AeroScout Enable/Disable : disable

FastPath Mode : on

Bonding Mode : single

AP150 Vcell : enable

Station Aging Out Period (minutes) : 2000To re-enable access to wireless clients, use

the management wireless command:

controller(config)# management wireless