Technical data

How Does the GUI Relate to CLI Commands?

Most System Director tasks can be accomplished using either the CLI or the GUI. Some

commands can only be done with one or the other. The chart below gives some exam-

ples of this. You can refer to the illustration on the previous page or click the indi-

cated links on the UI Interface.

I need to know... With the CLI With the GUI

Stations that are associated show station

show phones

Station table (Monitor > Devices > All Sta-

tions)

Stations and APs that are detect-

able

show ap-discovered Station table (Monitor > Devices > All Sta-

tions)

Controller setup show controller System Summary (Monitor > Dashboard >

System)

APs that are connected show ap Station table (click Monitor > Devices > All

Stations)

How are APs connected show ap-connectivity ap-id Station table (click Monitor > Devices > All

Stations)

How many stations are connected sh station or sh topostation Station table (Monitor > Devices > All Sta-

tions)

Stations connections to certain AP show ap-assigned mac-address Station table (Monitor > Devices > All Sta-

tions)

Add a new operating system ver-

sion to a controller using FTP

copy ftp://ftpuser:ftp-

passwd@offbox-ip-address/

meru-5.1-xxx-MODEL-rpm.tar.

upgrade system 5.1

See aggregate throughput for all

APs

NA System Dashboard (Monitor > Dashboard

System)

Syslog message summary show syslog-table shows the entire

log

SysLog Files Table (Monitor > Syslog >

View Syslog Files) shows a segment of the

log based on time

Alarms show alarms Alarm Dashboard (Monitor > Dashboard >

Alarms)

Rogues detected show rogue-ap-list Rogue AP Table (Monitor > Wireless

IDS/IPS > Rogue AP Table)

AP300/AP400 model (AP320, etc.) show ap