Technical data

288 Meru System Director Configuration Guide © 2012 Meru Networks, Inc.
Where Do I Start?
CLI controller
View controller-log history with the command
diagnostics-controller
If the problem is reproducible/occurring continually, log
your terminal session, enter the station-log interface
with the command station-log, and add the affected
MAC address using the command station add <MAC>.
If you DON'T know the MAC address, type event all all
to capture all events for all MAC addresses.
3.6 CLI
stations or
controller
View controller-log history with the command
diagnostics-controller
If the problem is reproducible/occurring continually, log
your terminal session, enter the station-log interface
and add the affected MAC address using the command
station add <MAC>. If you DON'T know the MAC
address, type event all all to capture all events for all
MAC addresses.
3.6 Web UI
stations or
controller
The command snort enables wireless sniffing from
multiple APs simultaneously. You will need a WireShark
client to retrieve captured output. It is best to configure
snort from the GUI as it allows multiple AP selection per
sniff. If you want to use the CLI, type the following from
the CLI prompt:
configure terminal
snort ip-address <IP of WireShark laptop>
snort port 9177
snort integration enabled
The command snort integration enabled is what turns
on the sniff at each AP selected. Make sure that you
always type snort integration disabled to disable the
sniff after data gathering is complete.
Web UI or CLI?
Problem
Involves?
Strategy