Technical data

212 Meru System Director Configuration Guide © 2012 Meru Networks, Inc.
Add and Configure an AP with the CLI
connectivity l2-only |
l2-preferred |
l3-preferred
For AP300/AP400, AP100, and AP150, this setting configures
Layer 2 or Layer 3 connectivity to the controller. Using either L3
or L2 preferred also invokes AP connectivity mode where
additional connectivity configuration can be done.
dataplane-encryption {on |
off}
In a Mesh configuration, selects how the AP and Controller pass
data packets:
On: the AP-Controller link is encrypted
Off: the AP-Controller link is unencrypted (default)
description string
Enters AP description. Note that this corresponds to the AP Name
in the GUI.
floor string
Enters AP floor location
led {normal | blink | NodeId
| Normal}
Sets LED appearance on AP300/AP400 and AP1000.
Normal: AP300/AP400 and AP1000 LEDs appear as described in
the Meru Access Point Installation Guide
Blink: Sets all LEDs flashing; this is useful to locate an AP
Dark: Turns off all LEDs
link-probing duration
minutes
For Remote AP, set the number of minutes between keep-alive
signals. Minutes can be between 1 and 3200.
location string
Enters AP location information
mac-address
ff:ff:ff:ff:ff:ff
Sets the MAC address if you are pre-configuring an AP
model string
Command to enter the model type of the AP if you are
pre-configuring the AP
no boot-script
Disables the boot script
end
Return to privileged EXEC mode.
Command Purpose