Technical data

Add and Configure an AP with the CLI

To configure an AP with the CLI, first enter AP configuration mode (first command

shown below) and then use the rest of the AP configuration commands:

802.11n Only

Mode

802.11n only mode is for AP300/AP400/AP1000s with N capability.

Select:

On: to support only 802.11n

Off: (default) to support 802.11an or 802.1bgn

Virtual Cell Virtual Cell Mode enables Virtual Cell for AP300/AP400 only.

On: enable per-station Virtual Cell on AP300/AP400

Off: (default) disable per-station Virtual Cell on AP300/AP400

Field Description

Note:

AP1000 radios always have Virtual Cell enabled, but there is a way to use AP1000

in non-Virtual Cell mode.

See Adding an ESS with the CLI.

Command Purpose

configure terminal

Enter global configuration mode.

ap ap-id

Enter AP configuration for the specified AP. Use the command

show ap to get a list of APs.

... commands ...

Enter the AP configuration commands listed in the next chart

here.

boot-script string

Name of an initialization script that the access point runs when

booted. If nothing is configured here, the AP uses the default

bootscript.

building string

Command to describe building identification.

contact string

Enters AP contact information