Technical data

190 Meru System Director Configuration Guide © 2012 Meru Networks, Inc.
Configuring Rogue AP Detection Using the CLI
----------------- -------------- --------------
00:0c:e6:cd:cd:cd 11/02 01:05:54 11/02 01:06:20
The commands to enable and confirm the rogue AP detection state are as follows:
controller (config)# rogue-ap detection
controller# show rogue-ap globals
Global Settings
Detection : on
Mitigation : none
Rogue AP Aging (seconds) : 60
Number of Candidate APs : 3
Number of Mitigating APs : 5
Scanning time in ms : 100
Operational time in ms : 400
Max mitigation frames sent per channel : 10
Scanning Channels :
1,2,3,4,5,6,7,8,9,10,11,36,40,44,48,52,
56,60,64,149,153,157,161,165
RSSI Threshold for Mitigation : -100
Use the CLI command show rogue-ap-list to display all rogue clients and APs in the
network.
Rogue Mitigation Example
Rogue AP mitigation for APs in the blocked list is enabled and confirmed as follows:
controller# configure terminal
controller (config)# rogue-ap detection
controller (config)# rogue-ap mitigation selected
controller (config)# exit
controller# show rogue-ap globals
Global Settings
Detection : on
Mitigation : selected
Rogue AP Aging (seconds) : 60
Number of Candidate APs : 3
Number of Mitigating APs : 5
Scanning time in ms : 100
Operational time in ms : 400
Max mitigation frames sent per channel : 10
Scanning Channels :
1,2,3,4,5,6,7,8,9,10,11,36,40,44,48,52,
56,60,64,149,153,157,161,165
RSSI Threshold for Mitigation : -100