Technical data
138 Meru System Director Configuration Guide © 2012 Meru Networks, Inc.
RSA SecurID Authentication
5. Optionally change the Adaption Interval from 30 to a value of either zero or 5 -
10080 seconds. (The values 1-4 seconds are not supported.) The adaptation
interval determines how often channels can be automatically changed for this
controller.
6. Click Start Wizard.
7. Confirm by clicking OK twice.
Click Graph Help to see what the chart colors mean. Click Details on either chart to
see numeric values for the green bars in the charts. A summary of rogue scanning
parameters is presented at the bottom of the screen. Also, the adaptation period of
a periodic adaptation is shown if one is running. The view automatically refreshes
every minute.
Configure Proactive Dashboard Manager Using the CLI
The CLI command for Proactive Dashboard Manager is proactive-spectrum-manager
evaluate. This is an example:
mg-mc2# proactive-spectrum-manager evaluate
** Attention: Stations may be disconnected in this evaluation **
Are you absolutely sure [yes/No]? yes
Evaluation time [120s]? 10
View or Adapt [View/adapt]? adapt
Adaptation period [0] min (5-10080)? 0
For command details, see the Meru System Director Configuration Guide.
RSA SecurID Authentication
RSA SecurID is two-factor authentication mechanism. This authentication mechanism
primarily involves three components:
RSA SecurID Authenticator token (hardware based or software based) that
generates a unique authentication code
Note:
If rogue detection is not enabled on the network, PSM turns it on when
needed for evaluate mode, then turns it back off. For example, if you use the option
One Time Adapt, PSM turns on rogue detection, does a scan and then moves stations
to recommended channels immediately. This overwrites the running config and
reboots the APs (save it to make it permanent).
Blacklisted channels are never recommended. RS4000 and mesh radios are not
supported. The more non-Meru equipment on a channel, the lower the recommenda-
tion will be to use that channel. Do not use this feature with a multichannel config-
uration.