Technical data

96 Meru System Director Configuration Guide © 2012 Meru Networks, Inc.
N+1 Redundancy
2. Check that the software has started on the slave with the show nplus1 command
(note that no masters display in the Master Controllers list):
Slave(config)# do show nplus1
The system is not fully operational
--------------------------------------------------------------------------
slave(config)# do show nplus1
Current State : Passive
Non-Revertive mode : Disable
Wait to Restore (WTR) : 8 minutes
Master Timeout : 5 keepalives
Slave IP : 192.168.10.204
Slave Hostname : slave
License Type : Licensed
License Usage (Used/Tot) : 0/5
--------------------------------------------------------------------------
Master Controllers
Missed
Hostname IP Address Admin Switch Reason Adverts
SW Version
--------------------------------------------------------------------------
Slave#
3. Supply the hostname and IP address of each master controller in the cluster. You
will be prompted for the controller’s password to complete the addition:
Slave# configure terminal
Slave(config)# nplus add ScaleMasterThree 10.1.1.10
admin@10.1.1.10 Password:
4. Exit configuration mode and check that the master controller has been enabled
(the Admin status is now Enable):
slave(config)# exit
slave# show nplus1
------------------------------------------------------------------------------------------
Current State : Passive
Non-Revertive mode : Disable
Wait to Restore (WTR) : 8 minutes
Master Timeout : 5 keepalives
Slave IP : 10.1.1.21
Slave Hostname : Slave
License Type : Licensed
License Usage (Used/Tot) : 1/5
------------------------------------------------------------------------------------------
Master Controllers
Missed SW
Hostname IP Address Admin Switch Reason Adverts Version
------------------------------------------------------------------------------------------