User's Manual
Table Of Contents
- Installing AP832e
- Installing AP832i
- Cautions and Warnings
- Regulatory Information
- Approved Antennas
- Regulatory Specifications
- AP832e/i
- USA
- Canada. Industry Canada (IC)
- Europe—EU Declaration of Conformity and Restrictions
- Japan
- Manufacturing Information
- AP Plenum Requirements
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- VCCI Statement for Japan
- Guidelines for Operating Meru AP832e and AP832i Access point
- Industry Canada
- EU Regulatory Conformance
- Declaration of Conformity with regard to the R&TTE Directive 1999/5/EC
- Declaration of Conformity for RF Exposure
- This Device Meets FCC Guidelines for Exposure to Radio Waves
- This Device Meets the Industry Canada Guidelines for Exposure to Radio Waves
- Maximum EIRP
- Dual Concurrent Same Band Operation
Japan
© 2013 Meru Networks, Inc. Regulatory Information xlv
Japan
EN 55022 Statement (applicable to AP201 Rev 2, AP208 Rev 2 only).This is to certify
that the above models are shielded against the generation of radio interference in
accordance with the application of Council Directive 2004/108/EC, Annex I, 1a.
Conformity is declared by the application of EN 55022 Class B (CISPR 22). Compliance
is dependent upon the use of shielded data cables.
Model AP300
Model AP150
Singapore
For the AP201 Rev 2, AP208 Rev 2, and OAP180, the following approval information applies:
For the AP300 series, the following approval information applies:
Manufacturing Information
The AP1000 and AP300 are built in Taiwan. Factory information is provided under NDA and
upon request.
Model AP300 module rev 1
003WWA080094 003GZA080095 003XWA080096
003NY06122 0000 003GZ06030 0000 003WY06046 0000
DA103798
IDA Standards
Complies with
DB102245
IDA Standards
Complies with