User's Manual
Table Of Contents
- Installing AP832e
- Installing AP832i
- Cautions and Warnings
- Regulatory Information
- Approved Antennas
- Regulatory Specifications
- AP832e/i
- USA
- Canada. Industry Canada (IC)
- Europe—EU Declaration of Conformity and Restrictions
- Japan
- Manufacturing Information
- AP Plenum Requirements
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- VCCI Statement for Japan
- Guidelines for Operating Meru AP832e and AP832i Access point
- Industry Canada
- EU Regulatory Conformance
- Declaration of Conformity with regard to the R&TTE Directive 1999/5/EC
- Declaration of Conformity for RF Exposure
- This Device Meets FCC Guidelines for Exposure to Radio Waves
- This Device Meets the Industry Canada Guidelines for Exposure to Radio Waves
- Maximum EIRP
- Dual Concurrent Same Band Operation
xlvi Meru Access Point Installation Guide © 2013 Meru Networks, Inc.
AP Plenum Requirements
The products should be installed in accordance with all applicable, local regulations
and practices.
Manufacturers Federal Communication Commission Declaration of
Conformity Statement
Manufacturer:
Meru Networks, Inc
894 Ross drive,
Sunnyvale, CA 94089
USA
This device complies with Part 15 rules. Operation is subject to the following two
conditions:
4. This device may not cause harmful interference, and
5. This device must accept any interference received, including interference that
may cause undesired operation.
This device operates in the 5150-5250MHz and 5470-5725MHz bands and is therefore
restricted to indoor operation only per FCC guidance.
This equipment has been tested and found to comply with the limits of a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a residential environment. This equipment generates, uses, and radiates
radio frequency energy, and if not installed and used in accordance with the instruc-
tions, may cause harmful interference. However, there is no guarantee that interfer-
ence will not occur. If this equipment does cause interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to correct the interference by one of the following measures:
Access Point Models Certification Number
AP832e
AP832i