User's Manual

• bracket.
• Slide the AP433i downwards until the screws click into the holes. They
should seat fairly firmly.
• Slide the mounting bracket’s locking bar to the right, locking the AP in
place.
• If desired, use the provided clip to lock the bracket shut by sliding it
through the aligned holes on the right-hand side of the bracket.See
Figure 22, Locking the AP433i & 433is in Place
Figure 22, Locking the AP433i & 433is in Place
• Connect one end of the Ethernet cable to the switch and the other end to
the AP433i
Figure 23, Ports for AP433i & 433is
Caution!
Be sure to connect the Ethernet cable to the Ethernet port; the cable can
mistakenly be plugged into the Console port. If you do this, the AP won’t
power up