User's Manual

Table Of Contents

Install the AP400

Figure 6: AP400 Antennas in Ceiling and Wall Mount Configuration

Do not leave any antenna connectors unterminated. All connectors on the AP must be terminated with

antennas or with 50 ohm Reverse Polarity SMA terminators.

The attached antennas must be the same model; if you replace one antenna with a different type,

replace them all.

Install the Access Point

AP400 ships with a mounting bracket included in the box. This bracket is intended for installation as a

wall-mount; for mounting on a ceiling, no mount is typically required. See the following sections for

more specific details.

 Mount AP400 Horizontally on a Shelf

 Mount AP400 Vertically on a Wall

 Mount AP400 Below a Suspended Ceiling

 Mount AP400 Above a Suspended Ceiling (Plenum)

Mount AP400 Horizontally on a Shelf

When mounting an AP400 horizontally, no mounting bracket is required. Be sure to position the

antennas vertically when an AP400 sits on a surface. In order to ensure that the AP400 does not shift

much, attach the rubber feet provided in the box to the bottom of the AP.

Mount AP400 Vertically on a Wall

To mount an AP400 on a wall:

CONSOLE