User's Manual
Table Of Contents
- About This Guide
- Access Points
- Installing AP300
- Safety Precautions
- Best Practices for an AP300/AP200 Network
- Unpack the AP300
- Determine Power Requirements
- Installation Requirements
- Install the AP300
- Select a Location
- Attach the Provided Antennas
- Install the Remote Antenna Mount (optional)
- Install External ACC-ANT-MIMO-MNT Antenna with Three Connectors (optional)
- Install Remote ACC-ANT-6ABGN-24 Antenna with Six Connectors (optional)
- Install Antennas With One Connector (optional)
- Install the Access Point
- Check AP300 LED Activity
- Where to Go From Here
- Installing AP320i
- Installing AP200
- Installing AP150
- Installing OAP180
- Cautions and Warnings
- Regulatory Information
70 Meru Access Point Installation Guide © 2010 Meru Networks, Inc.
Checking LED Activity
Disconnected
Access point was once connected to a
controller and configured by the
controller, but can no longer find that
controller
Green/Purple/
Green/Purple
Standalone Remote
Access point is operating in a
standalone mode
Purple blink
Downloading
Downloading image or configuration
from the controller
Green/Blue
Green/Blue
Error State
Access point is in an error state.
Call Meru technical support
Red (blinking or
solid)
a. The AP200 LEDs cycle from bright to dim for each “blink.”
State Interpretation AP200 LED Cycle