User's Manual
Table Of Contents
- About This Guide
- Access Points
- Installing AP300
- Safety Precautions
- Best Practices for an AP300/AP200 Network
- Unpack the AP300
- Determine Power Requirements
- Installation Requirements
- Install the AP300
- Select a Location
- Attach the Provided Antennas
- Install the Remote Antenna Mount (optional)
- Install External ACC-ANT-MIMO-MNT Antenna with Three Connectors (optional)
- Install Remote ACC-ANT-6ABGN-24 Antenna with Six Connectors (optional)
- Install Antennas With One Connector (optional)
- Install the Access Point
- Check AP300 LED Activity
- Where to Go From Here
- Installing AP320i
- Installing AP200
- Installing AP150
- Installing OAP180
- Cautions and Warnings
- Regulatory Information
48 Meru Access Point Installation Guide © 2010 Meru Networks, Inc.
Check AP320i LED Activity
Set AP320i on a Shelf
You can remove the mounting bracket(s) before setting AP320i on a shelf - see Figure 25.
Figure 25: Remove the AP320i Ceiling Mount Bracket
Mount AP320i Below a Recessed Ceiling
RECESSED CEILING MOUNT KIT???
Check AP320i LED Activity
When AP320i first connects to the controller (and any time the access point is rebooted), the AP initial-
izes and then is programmed by the controller. When the AP first powers up, all LEDs are green. There-
after, the Status LED color reflects the various operating states.
Push clip toward AP300i
to release the unit from
the wall bracket.
Mounting
bracket
AP300i
00238