User's Manual
Table Of Contents
- Contents
- About This Guide
- AP300 Series Introduction
- Installing the AP300
- AP300 Brackets
- Specifications
- Regulatory Information
- Channels

24 Meru Access Point and Radio Switch Installation Guide © 2007 Meru Networks, Inc.
USA — Federal Communications Commission (FCC)
Radio Frequency Interference Requirements
Interf
erence Statement
These devices comply with Part 15 of the FCC Rules. Operation of the devices is
subject to the following two conditions: (1) The devices may not cause harmful inter-
ference, and (2) The devices must accept any interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B
di
gital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installa-
ti
on. This equipment generates, uses, and can radiate radio frequency energy. If the
equ
ipment is not installed and used in accordance with the instructions, the equip-
ment may cause harmful interference to radio communications. There is no guar-
an
tee, however, that such interference will not occur in a particular installation. If
this
equipment does cause harmful interference to radio or television reception
(w
hich can be determined by turning the equipment off and on), the user is encour-
aged
to try to correct the interference by taking one or more of the following
measures:
Relocate this device.
Increase the separation between the device and the receiver.
Connect the device into an outlet on a circuit different from that of other
electronics.
Consult the dealer or an experienced radio technician for help.
Th
is device must not be co-located or operating in conjunction with any other
antenna
or transmitter.
Note:
Meru Networks Meru Access Point
These devices are restricted to indoor use because they operate in the
5.15 to 5.25 GHz frequency range. The FCC requires such products to be
used indoors for the frequency range 5.15 GHz to 5.25 GHz to reduce the
potential for harmful interference to co-channel Mobile Satellite systems.
Note:
The Meru Networks Meru Access Point must be installed and used in strict
accordance with the manufacturer’s instructions as described in the user
documentation that comes with the product. Any other installation or use
may violate FCC Part 15 regulations. Modifications not expressly approved
by
Meru Networks, Inc. could void your authority to operate the equip-
ment.