User's Manual

14 Meru AP300 Guide © 2007 Meru Networks, Inc.
Configure AP300 Software
mode AP mode configuration.
no Disables various parameters.
power Transmit power in the format low,medium,high.
For example, 20,20,20.
preamble-short Enables short preamble.
protection-cts-mode B/G protection mechanism.
protection-mode bg protection mode.
rf-mode Configure the Radio Frequency mode (802.11a, b,
g, bg, an
, or bgn).
show Displays various parameters related to this
wireless interface.
7. Change channel width from 20 MHz (default) to 40 MHz with the CLI command channel-
width. For example:
default(config-if-802)# channel-width ? ***help shows options***
20-mhz 20 MHz.
40-mhz-extension-channel-above 40 MHz Extension channel above.
40-mhz-extension-channel-below 40 MHz Extension channel below.
default(config-if-802)# channel-width above 40 MHz Extension channel
****changes channel width****
8. Change MIMO Mode from 2x2 (default) to 3x3 with the mimo-mode 3x3 command. For
example:
default(config-if-802)# mimo-mode 3x3 *****changes MIMO ****
default(config-if-802)# end
default#
default
Configure AP300 Using the GUI
Follow these steps to change Power Supply Type, Channel Width, and MIMO Mode using the GUI:
1. Enter the IP address of the controller in your browser. You see the controller GUI interface.
2. From the controller GUI, click Configuration > Devices > APs. The AP Table shown in
Figure 9 is displayed.