User's Manual

Configure AP300 Software
© 2007 Meru Networks, Inc. Installing the AP300 13
default(config)# ap 1 *******changes to ap config****
default(config-ap)# ? *******help lists options****
boot-script Configure boot script for this AP.
building Building location for this AP.
connectivity Manage AP connectivity.
contact Contact person for this AP.
dataplane-mode Determine whether the data packets go through the
controller or not.
default Reset to default values
description Description of AP.
do Executes an IOSCLI command.
end Save changes, and return to privileged EXEC mode.
exit Save changes, and return to global configuration mode.
floor Floor location for this AP.
high-density-enable Enable high density.
led Configure LED settings.
link-probing-duration Duration AP waits before rebooting when
controller link is down.
location Location of this AP.
mac-address Assign a new MAC address or pre-provision AP.
model Assign AP HW type.
no Disables various parameters.
power-supply Power Supply mode for this AP.
show Displays various parameters related to this AP.
4. Set the power supply with the CLI command power supply. For example:
default(config-ap)# power-supply ? *******help lists options****
5V-DC 5V-DC for AP Power.
802.3-af 802.3af Power Over Ethernet.
802.3-at 802.3-at Power Over Ethernet.
dual-802.3-af dual-802.3-af Power Over Ethernet.
default(config-ap)# power-supply 5V-DC ***changes power to 5V***
5. Exit configuration mode with the CLI command exit.\
6. Switch to radio channel configuration with the CLI command interface Dot11Radio #
#. For example:
default(config-ap)# exit
default(config)# interface Dot11Radio 1 1 ***switches to radio channel
config***
default(config-if-802)# ? ****help lists options*****
admin-mode Administrative Mode.
antenna-property Manage external wireless interface antennas.
antenna-selection Antenna configuration.
channel Configure the channel ID.
channel-width Configure the Channel Width for 802.11n
default Set various parameters to the default value.
do Executes an IOSCLI command.
end Save changes, and return to privileged EXEC
mode.
exit Save changes, and return to global configuration
mode.
fixed-channel Fix channel so it cannot be changed by auto-
channel configuration.
mimo-mode Configure the MIMO mode