User's Manual

8 Meru AP300 Guide © 2007 Meru Networks, Inc.
Install the Access Points
z Access to wall outlet or a to a Power over Ethernet (PoE) connection to the network switch
servicing the controller.
Most installations receive the best coverage using the following guidelines:
z Install APs toward the center of the building.
z Do not install APs near metal objects, such as heating ducts, metal doors, or electric
service panels.
z Relative to the ground, orient the antenna up or down, not sideways.
Attach the AP300 Antennas
The AP300 has six external antenna ports, labeled 1 - 6. AP320 and AP311 use all six antennas.
AP310 uses three antennas (1 - 3). Make sure that all external antennas and their associated
wiring are located entirely indoors. The external antennas are not suitable for outside use.
Figure 4: AP320 Antennas 1-6
Attach Standard Antennas
All standard attached antennas must be the same model. If you replace one antenna, replace
them all. These antennas are supported:
z Antenna Standard multiband, omni-directional white antenna (included)
z Standard Antenna Gain ~ 2.2 dBi for 2.4 GHz,and 3 dBi for 5 GHz
z RP SMA connectors for external antenna options
Make sure that all external antennas and their associated wiring are located entirely indoors.
The external antennas shipped are not suitable for outside use.
Note: The previous guidelines are general guidelines. Each site has its own unique
environment. Place access points accordingly.
A
2
A
2
A
L
A
N
R
F
1
R
F
2
2
00207
1
2
3
4
5
6