User's Manual

Federal Communications Commission (FCC) Declaration of Conformity (DoC) & Instructions
Regulatory Information 49
We, the responsible party, Meru Networks Inc., declare that the above-listed product, Wireless Access
Point AP200 Rev. 2 Model Nos. 202 & 209, was tested to conform to the applicable FCC Rules and
regulations. The method of testing was in accordance to the most accurate measurement standards
possible, and that all necessary steps have been enforced to assure that all production units of the same
equipment will continue to comply with the Federal Communications Commission’s requirements.
Issue Date: [TBD]
Srinath Sarang
VP, Product Management
Instructions
Warnings
This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in
accordance with the instructions, these products may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try and correct the
interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the distance between the equipment and the receiver.
3. Connect the equipment to an AC outlet on a circuit different from that to which the receiver is
connected.
4. Consult the dealer or an experienced radio/TV technician for help.
Address 1309 S. Mary Ave.
Sunnyvale, CA 94087
Contact Person/Title Mohammad Sa-id
Senior Regulatory Compliance Manager
Phone - [phone]
Fax - [phone]
EUT Certification Summary
Equipment Class Class B
Report References [TBD]
Issue Date [TBD]
Tested by Bay Area Compliance Lab
Company Information