User's Manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- About This Guide
- About Meru Access Points
- Installing the AP200
- Installing the AP150
- Specifications
- Regulatory Information
- Translated Safety Warnings
- Channels
Checking LED Activity
Installing the AP150 39
AP150 Status LEDs
Four status LEDs on the face of the AP150 also light, as shown in Figure 27.
.
Figure 27: AP150 Status LEDs
The functions of the status LEDs are described in Table 8.
When the AP150 is first connected to the controller and any time the access point is rebooted there-
after, the AP initializes with and then is programmed by the controller. When the AP is first powered
up, all LEDs are green. Thereafter, the Status LED (see Figure 27) color reflects the various operating
states (Tabl e 8).
AP200
RF2
RF1
STATUS
POWER
11
3