User's Manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- About This Guide
- About Meru Access Points
- Installing the AP200
- Installing the AP150
- Specifications
- Regulatory Information
- Translated Safety Warnings
- Channels
38 Meru Access Point Installation Guide
Where to Go From Here
Where to Go From Here
Now that the AP150 is installed, go to the Meru Wireless LAN Getting Started Guide for instructions
on initializing the controller and connecting the controller and APs to the Ethernet switch to form the
WLAN. Return to this section to check the status of the LEDs once the WLAN is operational.
Checking LED Activity
Access point status LEDs are provided on the Ethernet connector and on the face of the AP150.
Ethernet Connector LEDs
After the AP150 is connected, the LEDs near the RJ-45 connector should light, as shown in Figure 26.
Figure 26: RJ-45 LEDs
The green LED on the left blinks if any Ethernet activity is taking place. If there is no Ethernet activity,
the LED is off. The LED on the right is solid green if an Ethernet link is present. If no Ethernet link
is present or connectivity is lost, the LED is off.
Ethernet activity
Link present
00129