User's Manual

Installing the Access Point
Installing the AP150 31
Figure 17: AP150 Antenna Connection
3. Connect one end of the PoE 100BaseT Ethernet cable to the 100/1000 Ethernet connector, shown
in Figure 18.
Figure 18: AP150 Connector Panel
Vertical Mounting
To vertically mount an AP:
1. Using the bracket holes as a template, mark the location on the wall for the two AP bracket
mounting screws. They are placed 4 ½ inches apart, center-to-center, one above the other. If you
are not using plastic wall anchors, you must center the mounting screws on a wall stud. If you do
not center the mounting screws on a wall stud, you must use plastic wall anchors.
Turn clockwise
to tighten
A
ntenna
Access Point 200
ETHERNET
3.3 VDC
ANT 2
00110
Caution! Be sure to connect the Ethernet cable to the Ethernet port; the cable can mistakenly be
plugged into the Console port.
00032
Antenna 1
Antenna 2
Power
inlet
(Reserved)
100/1000
Ethernet
(Reserved)
Console
port
Reset
(Push to restore
default settings)