User's Manual

26 Meru Access Point and Radio Switch Installation Guide © 2007 Meru Networks, Inc.
Installing the RS4000
Mounting the RS4000 in the Hoffman/NEMA Enclosure
To mount the RS4000 in the Hoffman/NEMA enclosure, it is necessary to use the
optional mounting plate that is not supplied with the RS4000 packing items. This
procedure assumes the Hoffman/NEMA enclosure is already mounted at the site.
1. Remove the wall bracket from back of the RS4000, if attached, by unscrewing
each of the 4 knurled thumbscrews.
2. Attach the Hoffman/NEMA mounting plate to the back of the RS4000.
3. Attach the right-angle elbow joint to the antenna cable, if not already attached.
4. Attach the two antenna cables to the SMA antenna connectors labeled
ANT1 and
ANT2 on the top panel of the RS4000 (see Figure 8) by turning the cable ends
clockwise until tight.
5. Attach two Ethernet cables to the Ethernet ports labeled
ETH1 and ETH2 on the
top panel of the RS4000.
6. Place the RS4000 into the Hoffman/NEMA enclosure, and align the plate
screwholes with the holes in the Hoffman/NEMA enclosure.
7. Pass the Ethernet and antenna cables out of the Hoffman/NEMA enclosure through
the cable pass-through holes.
8. Tighten the captive screws on the mounting plate to the Hoffman/NEMA
enclosure.
9. Attach the antenna cables to the antenna (see Figure 15).
10. Position and align the bottom of the antenna over the threaded stud on the
antenna mount arm and tighten the threaded stud to the antenna.
Figure 18: RS4000 and Antenna Installed in NEMA Enclosure
Caution! This method of mounting has not been evaluated by Underwriters
Laboratories.
00188
RS4000AntennaNEMA box