User's Manual

Installing the RS4000
© 2007 Meru Networks, Inc. Installing the RS4000 19
7. Attach a keps nut to each caddy fastener stud and hand tighten. Do not
overtighten.
8. On the RS4000, attach the two antenna cables to the SMA antenna connectors
labeled
ANT1 and ANT2 on the top panel of the RS4000 (see Figure 8) by turning
the cable ends clockwise until tight.
Figure 10: RS4000 with Antenna Attached
9. Attach at least one Ethernet cable to the Ethernet port labeled
ETH1 and
optionally to
ETH2 on the top panel of the RS4000. If just ETH1 is connected, only
two of the four radios will be active.
10. Align the RS4000 to the bracket and tighten the four knurled thumbscrews until
secure. If necessary, apply extra tightening with pliers.
11. Attach the antenna cables to the antenna, as described in “Placing and
Positioning the Antenna.”
12. Connect the two Ethernet cables to the PoE device.
13. Apply power to the PoE component and network switch to power up the RS4000.
14. Verify correct operating using the LEDs, as shown in “Checking LED Activity.”
K
00182
ANT1 ANT2
ETH1
ETH2
ANT1
ANT2
(Meru logo is upside down)