User's Manual
Table Of Contents
- About This Guide
- Meru Access Points and Radio Switch
- Installing the RS4000
- Installing the AP200
- Installing the AP150
- Specifications
- Regulatory Information
- Channels
- Mounting Bracket Stencils
16 Meru Access Point and Radio Switch Installation Guide © 2007 Meru Networks, Inc.
Installing the RS4000
6. Screw in the screws most of the way, so that the screw head is about 1/16 of an
inch from the wall.
7. Mount the bracket on the screws, placing the circular portion of the keyhole
mounts over the screw heads and sliding the bracket down.
Figure 7: RS4000 Bracket Mounting
8. Tighten the bracket captive screws to secure the RS4000 to the bracket.
9. On the RS4000, attach the two antenna cables to the SMA antenna connectors
labeled
ANT1 and ANT2 on the top panel of the RS4000 (see Figure 8) by turning
the cable ends clockwise until tight.
POWER
RADIO I
RADIO II
ETHERNET
00186
Wall mounting bracket
(attached to wall)
RS4000
Captive screws (4)