Installation Guide

Table Of Contents

Installing the Access Points

Mounting Below a Suspended Ceiling

The optional suspended ceiling mounting kit allows the AP150 mounting bracket to

attach to suspended ceiling T-rails (see Figure 37).

Note:

To comply with NEC code, attach a grounding wire to any of the screws used

to attach the AP150 to the mounting bracket.

Figure 37: Mounting the AP150 to a Suspended Ceiling Rail

To mount an AP150 below a suspended ceiling:

1. Using a 1/8" Allen wrench, remove the shoulder screws from the mounting

bracket, if already attached.

2. Determine the location on the ceiling rail where the AP will be mounted and

remove the ceiling tiles.

3. Place each of the two caddy fasteners on the ceiling T-rail and twist to attach to

the rail.

4. Adjust the distance between the caddy fasteners by using the mounting bracket

holes as a guide.

5. Tighten the caddy fasteners in place using a standard screwdriver. Do not

overtighten.

6. Place each spacer on the caddy fastener stud. The spacer legs should contact the

ceiling T-rail.

7. Align the mounting bracket keyholes with the caddy fastener studs and slide the

AP150 to the narrow end of the hole.

00170

Washers

Suspended ceiling T-rail

Mounting bracke

Caddy fastener(

Spacer(s)