Installation Guide
Table Of Contents
- About This Guide
- Meru Access Points and Radio Switch
- Installing the RS4000
- Installing the AP200
- Installing the AP150
- Specifications
- Regulatory Information
- Channels
- Mounting Bracket Stencils
24 Meru Access Point and Radio Switch Installation Guide © 2007 Meru Networks, Inc.
Installing the RS4000
Figure 16: Antenna Mounting Arm with Wall Bracket (shown attached)
Figure 17: Antenna Ceiling Tile Rail Base
The RS4000 antenna uses two RF cables (3-foot cables are supplied) to connect to the
SMA connectors on the top panel of the RS4000 (see Figure 8). The RF cables should
be attached to the RS4000 as a result of the procedures described in one of the
previous installation procedures.
Mount the antenna and connect the cables as described in the following:
1. Choose whether to hang the arm on a wall (including solid ceiling wall) or ceiling
tile rail.
— For wall or ceiling mount:
a. Using the screwholes in the mounting bracket as a template, mark and drill holes
into the wall.
b. Attach the bracket securely with three 1/4" diameter fasteners or one 5/16"
diameter and one 1/4" diameter fastener, if mounting to a wall stud (fasteners
are not supplied).
— For ceiling tile rail mount:
a. Pull apart the rail clamps so the ears can fit over the width of the ceiling rail.
b. Squeeze the rail clamp to attach to the ceiling rail.
00180
Wall bracket base
Angle adjusting lever
Antenna attachment
stud (threaded)
00183