User's Manual

AP1014i LED Codes

1. From the controller, click Configuration > Devices > AP, and then select the AP.

2. Select one of these settings for the LED Mode setting:

— Normal: LED is as described above

— Blink: Sets the LED flashing; this is useful to locate an AP

— Dark: Turns off the LED

3. Click OK.

The following table describes the colors that can be displayed by the AP1014i Status LED and the details

corresponding to each color sequence.

Color State:

off

AP is off - either there is no power or the LEDs are set to Off on the

controller. Check the LED setting on the controller by clicking

Configuration > Devices > AP, selecting the AP and then checking the

setting for LED Mode.

cyan AP is booting stage 1.

green blinking AP is booting stage 2.

green/white alternating AP is discovering the controller.

green/blue alternating AP is downloading a configuration from the controller.

slow blue blinking AP is online and enabled.

rapid blue blinking AP is online and enabled and there is activity on one or both radios.

red/yellow alternating

Some AP failure occurred; check the controller for more details about

the alarm by clicking Monitor > Alarms > Pending Alarms.

blue/yellow alternating

AP is online and enabled and one or both radios are either scanning or

an admin has taken the radio(s) down.