User's Manual

Installing the Meru Air Point 100 5
Revision 0.1, September 2003 (9/22/03)
Installing the Access Point
7. Slide the access point into the mounting bracket as shown in the following
diagram. Slide the bracket’s feet over the two feet of the access point closest to the
keyhole mounts.
Figure 2: Attaching the Access Point to the Mounting Bracket
8. Position the small holes on the bracket over the small holes on the back of the
access point. Use two screws supplied to attach the bracket to the access point.
9. Point the antennas up.
10.Return the ceiling tile to the ceiling, but leave the tile loose.
11. Connect the PoE 100BaseT Ethernet cable to the access point.
12.Reposition the antennas, if needed.
13.Replace the ceiling tile in the ceiling brackets.
Attach with
Slide into
bracket
mounting screws
#6 screw
#6 screw