User's Manual

2 Installing the Meru Air Point 100
Revision 0.1, September 2003 (9/22/03)
Installing the Access Point
z
Underneath a horizontal surface, usually a ceiling.
z Above a ceiling tile.
To complete this installation, you need the following consumable items:
You need the following tools:
Installing the Access Point
Selecting a
Location
The access point requires a location that has both
Installation Type Consumable Items Required
Horizontal mounting None
Vertical mounting over a wall stud z Two #6 screws
Vertical mounting on sheetrock
z Two #6 screws
z Two plastic wall anchors
Horizontal mounting below a ceiling z Two #6 screws
z Two plastic wall anchors
Mounting above a ceiling tile z Two #6 screws
Installation Type Tools Required
Horizontal mounting None
Vertical mounting over a wall stud
z Drill
z 1/8-inch drill bit
z Screwdriver
Vertical mounting on sheetrock z Drill
z 3/16-inch drill bit
z Screwdriver
Horizontal mounting below a ceiling
z Drill
z 3/16-inch drill bit
z Screwdriver
Mounting above a ceiling tile z Drill
z 1¼-inch hole saw
z Screwdriver