Installation Instructions
Table Of Contents
- Contents
- About This Document
- Key Concepts
- CLI Command Reference
- Overview
- Alarms Commands
- asc: Subcontroller Commands
- ats: Access Point Commands
- auth: RADIUS Authentication Commands
- Channel BSSID Commands
- connect or remote: Remote Connection Commands
- Console Commands
- db: Configuration Backup Commands
- Help Commands
- History Commands
- if...stats: Interface Statistics Commands
- if: Interface Commands
- qoS or codec: Quality of Service Commands
- qosrule or ruleQoS: Rule Commands
- Quit Commands
- Reboot (or restart) Commands
- security: RADIUS Security Commands
- SNMP Commands
- Station Commands
- topo: Network Topology Commands
- Watchdog Commands
- wirelessif or wif: Wireless Interface Commands
- wnc: Controller Commands
- Glossary
- Index
PRELIMINARY
64 CLI Command Reference
Revision 0.1, July 2003
wnc: Controller Commands
wnc set
Sets one or more of the configuration values for the specified controller.
Syntax wnc set
desc=<val>
location=<val>
contact=<val>
{beaconinterval=<val> | beacon=<val>}
{assignmentalgo=<val> | assign=<val>}
virtualip=<val>
virtualnetmask=<val>
dhcp=<val>
virtualmac=<val>
essid=<val>
atsscript=<val>
polling=<val>
audit=<val>
Assignment Algo-
rithm
Assignment Algorithm.
Virtual IP Subnet
Address
This value, when masked by the virtual netmask value, specifies the
virtual IP subnet for mobile clients. All nodes must be rebooted for a
new value to take effect.
Virtual Netmask This value is used to mask the virtual IP subnet address to specify the
virtual IP subnet for mobile clients. All nodes must be rebooted for a
new value to take effect.
DHCP Server IP
Address
IP address of the DHCP server.
Virtual MAC Address The one virtual MAC address for all access points (ATSs).
ESSID The Extended Service Set ID for the network.
Default ATS Init
Script
Default ATS init script.
Statistics Polling
Period
Statistics polling period, in seconds (0 = no polling).
Field Description