Installation Instructions
Table Of Contents
- Contents
- About This Document
- Key Concepts
- CLI Command Reference
- Overview
- Alarms Commands
- asc: Subcontroller Commands
- ats: Access Point Commands
- auth: RADIUS Authentication Commands
- Channel BSSID Commands
- connect or remote: Remote Connection Commands
- Console Commands
- db: Configuration Backup Commands
- Help Commands
- History Commands
- if...stats: Interface Statistics Commands
- if: Interface Commands
- qoS or codec: Quality of Service Commands
- qosrule or ruleQoS: Rule Commands
- Quit Commands
- Reboot (or restart) Commands
- security: RADIUS Security Commands
- SNMP Commands
- Station Commands
- topo: Network Topology Commands
- Watchdog Commands
- wirelessif or wif: Wireless Interface Commands
- wnc: Controller Commands
- Glossary
- Index
PRELIMINARY
CLI Command Reference 59
Revision 0.1, July 2003
wirelessif or wif: Wireless Interface Commands
wirelessif or wif: Wireless Interface
Commands
These commands manage 802.11 wireless interfaces (the antennae on access points)
Each interface is uniquely identified by a node ID.
wirelessif all
Displays configuration information for all wireless interfaces managed by the
controller. See wirelessif get for details.
Syntax wirelessif all
wirelessif get
Displays configuration information for one or more wireless interfaces.
Syntax wirelessif get <node_id> [...]
Description Displays the following fields for each of the nodes requested:
Argument Description
node_id One or more node numbers identifying wireless interfaces that are associated
with this controller. Information is displayed for all the listed interfaces.
NOTE:
To list information for all wireless interfaces, use wirelessif
all
.