Installation Instructions
Table Of Contents
- Contents
- About This Document
- Key Concepts
- CLI Command Reference
- Overview
- Alarms Commands
- asc: Subcontroller Commands
- ats: Access Point Commands
- auth: RADIUS Authentication Commands
- Channel BSSID Commands
- connect or remote: Remote Connection Commands
- Console Commands
- db: Configuration Backup Commands
- Help Commands
- History Commands
- if...stats: Interface Statistics Commands
- if: Interface Commands
- qoS or codec: Quality of Service Commands
- qosrule or ruleQoS: Rule Commands
- Quit Commands
- Reboot (or restart) Commands
- security: RADIUS Security Commands
- SNMP Commands
- Station Commands
- topo: Network Topology Commands
- Watchdog Commands
- wirelessif or wif: Wireless Interface Commands
- wnc: Controller Commands
- Glossary
- Index
PRELIMINARY
CLI Command Reference 57
Revision 0.1, July 2003
Watchdog Commands
Watchdog Commands
{watchdog | wd}
Syntax {watchdog | wd}
To disable the watchdog, set the polling period to zero. To enable the watchdog, set
the polling rate to any period larger than zero.
watchdog get
Displays the current state of the watchdog.
Syntax watchdog get
watchdog set
Set the heartbeat polling period to <polling-time> seconds. Setting the polling-time
to zero disables the watchdog
Syntax watchdog set <polling-time>