Installation Instructions
Table Of Contents
- Contents
- About This Document
- Key Concepts
- CLI Command Reference
- Overview
- Alarms Commands
- asc: Subcontroller Commands
- ats: Access Point Commands
- auth: RADIUS Authentication Commands
- Channel BSSID Commands
- connect or remote: Remote Connection Commands
- Console Commands
- db: Configuration Backup Commands
- Help Commands
- History Commands
- if...stats: Interface Statistics Commands
- if: Interface Commands
- qoS or codec: Quality of Service Commands
- qosrule or ruleQoS: Rule Commands
- Quit Commands
- Reboot (or restart) Commands
- security: RADIUS Security Commands
- SNMP Commands
- Station Commands
- topo: Network Topology Commands
- Watchdog Commands
- wirelessif or wif: Wireless Interface Commands
- wnc: Controller Commands
- Glossary
- Index
PRELIMINARY
About This Document
vii
Revision 0.1, July 2003
About This Document
This document describes the command-line interface (CLI) commands for the Meru
Wireless Networking Product.
It briefly explains some of the concepts that you need to know before using the
commands.
Audience
This guide is intended for network administrators who will install, configure, and
maintain a Meru wireless network. It assumes that you are familiar with the
following:
Wireless networking
Basic IP routing concepts
In This Guide
This guide includes the following chapters:
Chapter 1, “Key Concepts,”
which provides useful information about Meru wire-
less networking
Chapter 2, “CLI Command Reference,”
which lists alphabetically all of the
commands in the Meru command-line interface
“Glossary”
which defines some terms used in this document