Installation Instructions
Table Of Contents
- Contents
- About This Document
- Key Concepts
- CLI Command Reference
- Overview
- Alarms Commands
- asc: Subcontroller Commands
- ats: Access Point Commands
- auth: RADIUS Authentication Commands
- Channel BSSID Commands
- connect or remote: Remote Connection Commands
- Console Commands
- db: Configuration Backup Commands
- Help Commands
- History Commands
- if...stats: Interface Statistics Commands
- if: Interface Commands
- qoS or codec: Quality of Service Commands
- qosrule or ruleQoS: Rule Commands
- Quit Commands
- Reboot (or restart) Commands
- security: RADIUS Security Commands
- SNMP Commands
- Station Commands
- topo: Network Topology Commands
- Watchdog Commands
- wirelessif or wif: Wireless Interface Commands
- wnc: Controller Commands
- Glossary
- Index
PRELIMINARY
46 CLI Command Reference
Revision 0.1, July 2003
security: RADIUS Security Commands
security set
Sets one or more of the configuration values for security.
Syntax security set
[privacy=<val>]
[{securitymode=<val> | mode=<val>}]
[{radiusip=<val> | ip=<val>}]
[{radiusport=<val> | port=<val>}]
[{radiussecret=<val> | secret=<val>}]
[rekeyperiod=<val> | rekey=<val>}]
Description Sets one or more of the following values:
Description The controller must be reooted for the changes to take effect.
Argument Description
privacy The privacy state that the ATSs should use; valid values are ON, OFF, or
AUTO.
securitymode
(or mode)
The security mode that the ATSs should use; either OPEN or 802.1x.
radiusip (or ip) IP address of the RADIUS server in nnn.nnn.nnn.nnn format. The controller
must be rebooted for this to take effect.
radiusport (or
port)
Port number to use to connect to the RADIUS server. The controller must
be rebooted for this to take effect.
radiussecret (or
secret)
The RADIUS secret. The controller must be rebooted for this to take effect.
rekeyperiod (or
rekey)
The rekey period, in seconds. The controller must be rebooted for this to
take effect.