Installation Instructions
Table Of Contents
- Contents
- About This Document
- Key Concepts
- CLI Command Reference
- Overview
- Alarms Commands
- asc: Subcontroller Commands
- ats: Access Point Commands
- auth: RADIUS Authentication Commands
- Channel BSSID Commands
- connect or remote: Remote Connection Commands
- Console Commands
- db: Configuration Backup Commands
- Help Commands
- History Commands
- if...stats: Interface Statistics Commands
- if: Interface Commands
- qoS or codec: Quality of Service Commands
- qosrule or ruleQoS: Rule Commands
- Quit Commands
- Reboot (or restart) Commands
- security: RADIUS Security Commands
- SNMP Commands
- Station Commands
- topo: Network Topology Commands
- Watchdog Commands
- wirelessif or wif: Wireless Interface Commands
- wnc: Controller Commands
- Glossary
- Index
PRELIMINARY
CLI Command Reference 37
Revision 0.1, July 2003
qosrule or ruleQoS: Rule Commands
Description Displays the following fields for each of the rules requested:
Argument Description
rule_id One or more numbers identifying QoS rules that are associated with this con-
troller. Information is displayed for all the listed items.
NOTE:
To list information for all rules, use qosrule all.
Field Description
Rule ID The unique numeric ID of the QoS rule.
Destination IP
Address
The destination IP address.
Destination Port The destination IP port.
Destination Netmask The destination address netmask.
Source IP Address The source IP address.
Source Port The source IP port.
Source Netmask The source address netmask.
Network Protocol Network protocol: 'udp' or 'tcp'.
QoS Protocol QoS protocol: 'sip', 'none', or 'h.323'.
VLAN ID The virtual LAN ID: from 0 to 4095.
Average Packet Rate Average packet rate: from 0 to 200 packets per second.
Action Action: - 'forward', 'capture' (default) or 'drop'.
Drop Policy. Drop Policy - tail, head.
TSpec Token Bucket
rate
TSpec Token Bucket rate, from 0 to 1,000,000 bytes per second
Priority value 0-low
8-high)
The number (0-8) that specifies best effort priority queue where 0 is
default (no priority) and 8 is highest priority
Traffic Control Polici-
ing
Valid values are 0 (zero) which turns it off, and P, which turns it on. By
default is not set <