Installation Instructions
Table Of Contents
- Contents
- About This Document
- Key Concepts
- CLI Command Reference
- Overview
- Alarms Commands
- asc: Subcontroller Commands
- ats: Access Point Commands
- auth: RADIUS Authentication Commands
- Channel BSSID Commands
- connect or remote: Remote Connection Commands
- Console Commands
- db: Configuration Backup Commands
- Help Commands
- History Commands
- if...stats: Interface Statistics Commands
- if: Interface Commands
- qoS or codec: Quality of Service Commands
- qosrule or ruleQoS: Rule Commands
- Quit Commands
- Reboot (or restart) Commands
- security: RADIUS Security Commands
- SNMP Commands
- Station Commands
- topo: Network Topology Commands
- Watchdog Commands
- wirelessif or wif: Wireless Interface Commands
- wnc: Controller Commands
- Glossary
- Index
PRELIMINARY
CLI Command Reference 11
Revision 0.1, July 2003
ats: Access Point Commands
ats upgrade
Installs upgraded software onto the ATS.
Syntax ats upgrade {<node-id> | all}
<version>
[noreboot | <delay>]
To upgrade the software on an ATS, enter its node id and the version that was previ-
ously downloaded onto the WNC. Available images may be listed using the 'ats
images' command. After the upgrade the ATS will reboot immediately when the
upgrade is complete, unless the 'noreboot' option or a delay (in seconds) is given as
the last argument.
Argument Description
desc Text description for this access point.
location Text description of the location of this access point.
contact Person or organization responsible for this access point.
bootscript The name of the script to run when the access point boots. Use ats
scripts to display the names of valid scripts. See wnc set for additional
information.