Installation Instructions
Table Of Contents
- Contents
- About This Document
- Key Concepts
- CLI Command Reference
- Overview
- Alarms Commands
- asc: Subcontroller Commands
- ats: Access Point Commands
- auth: RADIUS Authentication Commands
- Channel BSSID Commands
- connect or remote: Remote Connection Commands
- Console Commands
- db: Configuration Backup Commands
- Help Commands
- History Commands
- if...stats: Interface Statistics Commands
- if: Interface Commands
- qoS or codec: Quality of Service Commands
- qosrule or ruleQoS: Rule Commands
- Quit Commands
- Reboot (or restart) Commands
- security: RADIUS Security Commands
- SNMP Commands
- Station Commands
- topo: Network Topology Commands
- Watchdog Commands
- wirelessif or wif: Wireless Interface Commands
- wnc: Controller Commands
- Glossary
- Index
PRELIMINARY
4 CLI Command Reference
Revision 0.1, July 2003
Alarms Commands
Example To view the alarm log:
wnc> alarms
This produces output similar to the following:
Time (UTC) Node Type Severity
-------------- -------- ------------------------- -------------
07/17 17:25:55 ATS 0001 LINK UP CLEAR
Type Alarm type. One of the following:
LINK UP
LINK DOWN
ASC DOWN
ATS DOWN
WATCHDOG FAILURE
Severity The severity of the alarm, either CRITICAL or CLEAR (alarm state has
been cleared
Information Description